Manual System SPRINT Airfluid XE
SKU: 2355400
Using the Sprint Airfluid XE allows you to work directly out of the carton.
Ideal for small batches and frequent paint changes. All parameters are
set and saved via the EPG-Sprint XE. In combination with the PEM-X 1,
perfect surfaces are achieved.
Special advantages
- Corona manual gun with an air-flushed high-performance cascade. Constant and reliable coating performance
- Control unit with a regulated air volume cycle. A constant compressed air quantity despite fluctuations in the mains
- Fully electronic control unit for reproducible results. Saving and accessing up to 50 coating programs
- Diagonal position of the powder container. Powder carton is almost completely emptied
Processable materials
- Polyester powder coatings
- Epoxy powder coatings
- Metallic powder coatings
- Acrylic powder coatings
- UDS powder coatings
- Effect powder coatings
TECHNICAL SPECIFICATION
Technical data Input voltage 85 – 250 V Input power 40 W Input frequency 50 – 60 Hz Protection class IP 64 Air inlet pressure 0,6 – 0,8 MPa, 6,0 – 8,0 bar, 87 – 116 PSI Air inlet connection G 1/4‘‘ i Exhaust air flow 0,05 – 20,0 Nm³/h Operating temperature 5 – 45 °C, 41.0 – 113.0 °F INCLUDED ITEMS
- Corona manual gun PEM-X1
- Control device EPG-Sprint XE
- Injector PI-F1
- Suction lance with fluid cap
- Device cart with vibrating table
- Powder hose 5m (Ø 11mm)
- Mains cable 3m
- Grounding cable 10m
- Connection hose